BT-210 Set

■Features
The BT-210 is a product that uses Bluetooth communication to enable serial communication (UART).
The BT-210 covers the circuit with a case to protect it, and it uses a connector-type cable to install on a robot and RC-100B.
You can control your robot without any problems even when the infrared control condition is not optimal such as in a robot competition.

The SLAVE module can be used when controlling the robot from a device that supports Bluetooth communication such as a smartphone, tablet PC or notebook.

■Package compornents
BT-210(120mm cable included) x 2

■H/W Specifications

Weight	4.51g
Size	18mm x 30mm x 9.1mm
Bluetooth Specifications	Bluetooth Specification 2.1 Support
Effective Communication Range	10m
Bandwidth Frequency	2.4 GHz ISM Band
Bandwidth	MAX 250kbps
Default Baud Rate	57600bps
Sensitivity	-81dBm(Typical)
Transmit Power	4dBm(Typical)
Bluetiith Profile Support	SPP(Serial Port Profile)
Operating Voltage	3.3V
Consumed Current	48mA(MAX)
Operating Temperature	-40℃～85℃
Baud Rate Range	1,200bps～400,000bps
Antenna	Chip Antenna
Interface	UART(3.3V level)
Conducted Net Power	-6～4dBm(Class 2)

■Compatible Products
Controller：CM-530 (Wireless control, wireless download possible),
CM-510, CM-700 (Wireless control possible (firmware update required))

Remote Control：RC-100B


※Caution!!
The MASTER module and the SLAVE module are divided – MASTER module for the transmitter; SLAVE module for the robot.
When first released and purchased, the two modules are paired so there is no need for a separate ID setting procedure. If either of the components is lost, you will have to purchase the BT-210 for pairing.
Directions for pairing can be found in our e-Manual.
Click here to directions for pairing.

The initial Pin Code when released from factory is 0000. Use this when connecting to the Bluetooth device(SLAVE). When a change is needed, please refer to the link above. However, OpenCM-9.04-A or C type controller is required.
Installation Not Supported
-Controller : CM-100, CM-5, CM-2+
-Remote Control : RC-100, RC-100A